REDBACK 2Ch XLR Input to Dante Output Adapter Compact Design Black A3166

Overview

This Dante 2CH XLR Input Adapter is an audio transmitter based on the Dante Ultimo 2x2 solution. It converts two-channel balanced/unbalanced XLR analog audio into Dante 2CH digital audio, then transmits the audio to the receiving end through network (Dante). Analog audio input supports 5-level sensitivity adjustment. The adapter supports local USB-C port power supply and PoE function.

• Two-channel XLR analog audio to Dante 2CH digital audio
• Balanced/unbalanced XLR analog audio input
• Dante audio sampling rate supports 44.1/48/88.2/96KHz@24bit
• Dante audio delay supports 1/2/5ms (configurable)
• Analog audio input supports 5-level sensitivity adjustment (+24dBu, +4dBu, 0dBu, 0dBv, -10dBv)
• Supports local USB-C port power supply and PoE function (Class 0 802.3af PoE)
• Compact design for easy and flexible installation

Technical:

• Input: Two-channel balanced/unbalanced XLR analog audio
• Output: Dante 2CH digital audio
• Control Method: Dante Controller
• Video Network Bandwidth: 100M
• Audio Latency: Configurable Dante® device latency (Supports 1, 2 or 5ms configurable using Dante® Controller)
• Audio Formats: XLR IN [Analog audio input, Balanced/unbalanced 2CH, Max input level +24dBu] DANTE OUT [Digital audio output, PCM 2CH 44.1K-96KHz 16/24bit]
• Transmission Distance: 100m (CAT6/6A/7)
• ESD Protection: IEC 61000-4-2: ±8kV (Air-gap discharge) & ±4kV (Contact discharge)

Audio Parameters:

• XLR Analog Audio In
• Input Impedance: 20k Ohm balanced, 10k Ohm unbalanced
• Line Input Level (Maximum): +24dBu (12.28Vrms) @balanced audio, +18dBu (6.15Vrms) @unbalanced audio
• Frequency Response: 20Hz to 20kHz (-/+0.5dB)
• Dynamic Range: >100dB@0dBu, 1kHzA-weighted
• Audio S/N Ratio: >100dB@0dBu, 1kHzA-weighted
• Audio THD+N: < 0.01% at +4dBu, 1KHz
• Audio Output Sync Delay: <10ms
•  
• Connection:
• Input port: 2x CH1/CH2 XLR IN [XLR female plug, with 30cm cable], 1x POWER [USB-C power and firmware update port, 12-pin female]
• Output port: 1x DANTE [RJ45 connector, PoE]
• Others: 1x RESET button [System reboot button], 2x SENSITIVITY knob [5-level dip switch]
•  
• Mechanical:
• Housing: Plastic Enclosure
• Colour: Black
• Dimensions: 115mm [W] x 40mm [D] x 28 mm [H]
• Weight: 173g
• Power Supply: USB input: 5V/500mA, PoE input: PoE IEEE802.3af Class 0
• Power Consumption: 2W (Max)
• Operating Temperature: 0°C ~ 40°C
• Storage temperature: -20°C ~ 60°C
• Operating Humidity: 20% ~ 80% RH (relative humidity, non-condensing)
• Storage Humidity: 10% ~ 90% RH (relative humidity, non-condensing)