International Product Announcement.

This is a DIY product that provides as complete vector network measurements as possible in a credit card size. Includes a 2.8 inch touch screen, 400mAh battery, TX/RX mode measurement, can measure complete S11 and S21 parameters, if you need to get S12 and S22, you need to manually change the transceiver port wiring. If there are other imperfections, you can communicate with me.

● PCB: 54mm x 85.5mm x 11mm (without connector, switch)

● Measurement Frequency: 50KHz ~ 1.5GHz

● RF Output:-13dbm (max -9dbm)

● Frequency Accuracy:<2ppm

● Frequency Stability:<0.5ppm

● Measurement range: ● Measurement range: 70dB(50kHz-300 MHz),(50dB (300M-900MHz), 40dB (900M-1500MHz)); ● Port SWR: <1.5ppm; ● Port SWR: <1.5ppm.

● Port SWR: < 1.1

● Display: 2.8-inch TFT (320 × 240)

● USB Interface: USB type-C Communication Mode: CDC (Serial)

● Power supply: USB 5V 120mA, built-in 400mAh battery, maximum charging current 1A, can be used continuously for more than 4 hours

● Number of calibration points: 101 (fixed)

● Number of scanning points: 101 (fixed)

● Display Tracking: 4, Marker: 4, Setting Save: 5

Packing list:

1. NanoVNA main unit *1 (with 2.8-inch touch screen, 400mAh battery)

2. 20cm SMA male to male RG174 RF cable *2

3. Type-C to Type-C connection cable

4. USB Type-C cable *1

5. Simple manual *1

6. Touch pen *1

7.Dial *1

8. SMA simple calibration kit LOAD *1

9. SMA simple calibration kit OPEN *1

10. SMA simple calibration set SHORT *1

11. SMA female to female connector *1